A gas boiler, fuelled with natural gas, oil, LPG or propane (etc), is the most common kind of appliance used for central heating in Stanwardine In The Fields Shropshire SY4 and throughout the United Kingdom. It heats water which flows through pipes or a radiator, and it is used for hot water in the home as well as for a central heating system. It is also used for radiant floor heating systems. An annual boiler inspection and maintenance check by a registered “Gas Safe” gas boiler service heating engineer is essential for safety and comply with UK Law.
The Engineer will make sure that the heating system is installed according to regulations during the annual central heating and boiler inspection, that it is safe and it is working efficiently according to the manufacturers’ instructions. If this is done properly every year, gas boiler breakdowns and the resulting emergency repair work can often be avoided.
Stanwardine In The Fields Shropshire SY4 Super Low Energy Combi Boiler Inspection – A Number of Things You Should to Take Note Of
Worcester-Bosch are undoubtedly one of the leading manufacturers of gas fired boilers in the UK, with a rich history spanning 50 years of production, Worcester are one the household names to look for when purchasing a new gas boiler for your home.
In August 2012, Worcester announced the launch (although to many say it was a revision) of the new Greenstar CDi Classic Combination Boiler Range.
A total of 8 models of boilers have been launched, they are:
Greenstar 29Cdi Classic - (Formerly Greenstar 27Cdi)
Greenstar 34Cdi Classic - (Formerly Greenstar 30Cdi)
Greenstar 38Cdi Classic- (Formerly Greenstar 37Cdi)
Greenstar 42Cdi Classic - (Formerly Greenstar 42Cdi)
All models are available in either standard natural gas, or in an LPG option for those in remote locations.
So What's The Difference?
Most notably, the Greenstar Classic range have had a whole host of internal upgrades and improvements with the clever introduction of a more energy efficient standby mode. With consumers continually looking at ways to reduce their energy consumption within the home, Worcester have managed to reduce the standby electricity output of the CDi boilers from 9W to just 3.5W in the new CDi Classic Boilers.
This enables customers to benefit from a more energy efficient source of heating and hot water, which will have a positive impact on electricity bills. Therefore keeping a high standard in energy efficiency and maintaining the SEBUK A-Rated performance values in excess of 90% efficient.
The overall outputs of 27kW, 30kW and 37kW within the CDi range have been upgraded to 29kW, 34kW and 38kW in a move which substantially improves performance in flow rates, giving better hot water service to bathrooms and kitchens.
In addition to this increase in performance and reduction in energy consumption, the everyday operation has not been overlooked in this overhaul. The introduction of a magnetic flap access panel has greatly improved upon the Greenstar CDi's original push and click mechanism, a feature which often failed with many years of use.
With peace of mind and reduced costs on everyone's minds, Worcester haven't scrimped on the warranty either, with a current promotion of a full 5 Year parts and labour warranty on the boiler and a huge 10 Year Warranty on the primary heat exchanger.
Some features and benefits at a glance:
- Best boiler efficiency rating SEDBUK band A
- Fully condensing in both central heating and domestic hot water modes
- Keep hot facility - instantly available hot water
- Extremely small standby electrical output of 3.5W - energy efficient
- Wall mounting frame allows pipework to be hidden from view
- Vertical pre-piping kit
- Below boiler pipe cover
- Earth bonding strip
- Low NOx and CO2 emissions - environmentally friendly
- 5 year boiler guarantee until 31st December 2012, terms and conditions apply (standard guarantee: 2 years)
- 10 year guarantee on primary heat exchanger
- 5 year anti-scale guarantee on domestic hot water heat exchanger
- Hot water and central heating temperatures can be controlled
- Multi-directional fluing means boiler can be sited in a wider variety of places
- Mechanical, digital and new generation intelligent controls all compatible
- Heat load and flow generated precisely to meet the heating system's requirements using a modulating pump
With the introduction of the new Greenstar Classic Combination boilers in 2012, Worcester's continued program of improvements ensures they remain the UK's favoured choice for boiler manufacturer, there is no better time to purchase a combi boiler to reduce bills and save energy.
Buying a New Gas Boiler - What You Will Want to Know
The main theory of what a conventional non condensing boiler does is pretty simple. A boiler works by igniting a combustible fuel source (oil, natural gas, or LP gas), with an appropriate air mixture. The heat from the flame and hot combustion gases pass through a heat exchanger within the boiler, where water is heated and then circulated through radiators, under floor radiant tubing, and hot water cylinders throughout the house. The flue gases then escape through the chimney or venting system. A decent amount of heat is wasted with this type of boiler, where the heated gases are just directly vented out. These types of boilers have a lower efficiency rating; no higher than 75%. An efficiency rating is basically a gauge of how much energy the boiler transfers from fuel used to how much heat is supplied to the system.
Condensing boilers work a bit differently. They essentially have some of the same components non condensing boilers do, except for a second heat exchanger. One of the gases produced in the combustion of fuel is water vapour.Where the hot flue gases just got vented out in a traditional boiler; condensing boilers condense these vapours around a second heat exchanger before venting. By the time the gases are ready to be vented out they are much cooler, around 60 degrees Celsius. As a result the vent pipe used in installation can be made of PVC.
With these systems some of the internal components have to be made of more durable material, because the condensed water tends to be acidic with a 3-5 pH. This results in the cost of the condensing boiler being higher than average. The secondary heat exchanger is where the system return enters first. So by the time the water enters the primary heat exchanger it is already been preheated, allowing the boiler to work more efficiently. The efficiency rating from condensing boilers range from between 80% to 98%.
Combi boiler / Combination boiler
Combi boiler / Combination boiler is an excellent choice for homes with limited space. Combi boiler / Combination boiler is a domestic water heater and a central heating system combined into one unit. They have a heating coil inside of them, and function like an unlimited on-demand water heater. Combi boilers don't have cylinders or external holding tanks like traditional systems do, so they can be installed in areas where a typical system would never work.
Condensing Boiler Pros
1 They are fuel economical and have a 15-30% higher efficiency rating than non condensing counterparts
2 Considerable savings on annual energy expenses
3 Most units are very quite ( they make as much noise as a window mounted air conditioner)
4 Many Models could easily fit in a small closet and have combination boiler
5 They are more environmentally friendly with C02 output
Condensing Boiler Cons
1 Initial cost of the unit is more
2 Units need to have the acidic condensate fitted outside or to a waste line
3 The dwelling the boiler is installed in needs to be insulated well, otherwise the heat saved through efficiency will be lost through the walls.
4 Most units need an outdoor weather sensor to operate effectively
For Stanwardine In The Fields Shropshire SY4 Systems We Normally Advise Purchasing From The Our Recommended Combi Boiler Range
When the cold weather starts to show its nasty face, we all know that it won't be long before the home central heating is switched on to keep us warm. Sometimes though it decides not to work and you have to find someone who knows how to fix it.
A very small percentage of people have their boiler serviced every year without fail, these are the people who prepare for the colder months, knowing that when they need the heating on it will all be fine.
The majority of people though these days seem to forget or just don't bother to have the boiler serviced until it breaks down. The boiler is just like a car, you need to have the car checked over and oil added if needed, otherwise it will eventually breakdown.
I have listed 5 reasons below on why you should have the boiler serviced.
- One of the mains reasons why your boiler should be serviced each year is safety. When a service is carried out the flue pipe that removes the exhaust gas is checked over for leakage. Should a leak in the flue pipe be found, it could be producing carbon monoxide into the room that the boiler is located in, and we all know how dangerous to life it can be.
- We all like to keep warm in the winter months, but can you imagine coming home from work on a very cold evening only to find your home is cold because the boiler has stopped.
- The boiler fitted in your property normally supplies both hot water and heating throughout your home, should the boiler stop working you may find yourself taking a cold shower.
- If your boiler is either a combination or system boiler then it will be fitted with an expansion vessel somewhere, it could be fitted internal of the boiler or fitted externally close to the boiler. This vessel over time will loose its pressure and needs to be reset.
- The boilers of today are very highly tuned to give you the user the efficiency you require, when the service is carried out, the boiler is connected to a gas analyser to check on it efficiency and safety. Should the boiler need adjustments then it can be adjusted and checked over again.
If your boiler is around 11 years old or younger it will most likely be a high efficient condensing boiler. These boilers are not like the old style boilers that went on for many years without having a service. Those boilers were very costly to use, around 40% of your fuel bill went out of the boilers flue.
Today's condensing boilers have an efficiency rating of around 90%, that's a saving of around 30% on your fuel bill, but if fail to have the boiler serviced you will start see your fuel bills rise along with the fuel suppliers regular increase.
It's very important to have a regular boiler service because it will also increase the life of the boiler, if left then the life span becomes very low, and you will be changing the boiler at some stage, and we all know how costly that can be.
Top Tip, When you find someone to service your boiler, if the boiler works by gas then you must use a Gas Safe Registered Engineer to carry out the work for you. You must not use a friend or someone who says don't worry I can do it for you unless they are registered.
The boiler when working keeps us all warm with plenty of hot water, but when it stops it become a headache.