A gas boiler, fuelled with natural gas, oil, LPG or propane (etc), is the most common kind of appliance used for central heating in Poynton Green Shropshire SY4 and throughout the United Kingdom. It heats water which flows through pipes or a radiator, and it is used for hot water in the home as well as for a central heating system. It is also used for radiant floor heating systems. An annual boiler inspection and maintenance check by a registered “Gas Safe” gas boiler service heating engineer is essential for safety and comply with UK Law.
The Engineer will make sure that the heating system is installed according to regulations during the annual central heating and boiler inspection, that it is safe and it is working efficiently according to the manufacturers’ instructions. If this is done properly every year, gas boiler breakdowns and the resulting emergency repair work can often be avoided.
Poynton Green Shropshire SY4 Super Low Energy Combi Boiler Inspection – A Number of Things You Will Want to Take Note Of
Maintaining the boiler in a high state of repair should help with limiting any expensive bills in the future for significant repairs or even replacement of the boiler. Maintaining the boiler needn’t be time-consuming or expensive. Here are several steps that can be taken to make certain a boiler is able to operate more efficiently for the long-term:
Make certain the boiler manual is kept in a convenient location. Many people will lose or throw the manual for the boiler once it has been installed. But, if you do find that you are experiencing any difficulties in the future, you’ll find that the manual can be highly beneficial for troubleshooting the more common issues you are likely to experience. Also, you also want to make certain that you have access to the manual to help with programming the timing or similar settings that you might wish to change in the future.
Put in place a regular maintenance schedule. If you really want to make certain that the boiler system is maintained in a full operational condition, you might want to look having a regular 12 monthly service. A professional service is able to check all aspects of the boiler to make certain it is able to run efficiently. Ideally, you want to have a boiler serviced each year prior to the cold weather arriving.
Prevent the boiler from freezing. It is possible to prevent a boiler from freezing in the very low temperatures by leaving the heating on at a low range constantly. You might find that this isn’t the most economical solution and therefore you might want to look at other methods for preventing a boiler from freezing. Insulation of all the pipework is likely to be one of the more effective options.
Have faulty parts and systems replaced? A boiler isn’t able to operate to its full efficiency if parts are starting to fail. A thermostat that is getting old is likely to lose its ability to provide accurate readings in relation to the temperature setting. If you constantly have the heating at an unnecessary high level then this is certain to be a waste of energy.
If you do start to notice that a boiler isn’t able to operate as efficiently as desired, then it will certainly benefit if you are able to call on the services of the qualified plumbers who will be able to offer the most efficient solution for rectifying the problems.
Things to Look Out For in a Gas Boiler Service
The main theory of what a conventional non-condensing boiler does is pretty simple. A boiler works by igniting a combustible fuel source (oil, natural gas, or LP gas), with an appropriate air mixture. The heat from the flame and hot combustion gases pass through a heat exchanger within the boiler, where water is heated and then circulated through radiators, underfloor radiant tubing, and hot water cylinders throughout the house. The flue gases then escape through the chimney or venting system. A decent amount of heat is wasted with this type of boiler, where the heated gases are just directly vented out. These types of boilers have a lower efficiency rating; no higher than 75%. An efficiency rating is basically a gauge of how much energy the boiler transfers from fuel used to how much heat is supplied to the system.
Condensing boilers work a bit differently. They essentially have some of the same components non-condensing boilers do, except for a second heat exchanger. One of the gases produced in the combustion of fuel is water vapour. Where the hot flue gases just got vented out in a traditional boiler; condensing boilers condense these vapours around a second heat exchanger before venting. By the time the gases are ready to be vented out they are much cooler, around 60 degrees Celsius. As a result, the vent pipe used in installation can be made of PVC.
With these systems, some of the internal components have to be made of more durable material because the condensed water tends to be acidic with a 3-5 pH. This results in the cost of the condensing boiler being higher than average. The secondary heat exchanger is where the system return enters first. So by the time the water enters the primary heat exchanger it is already been preheated, allowing the boiler to work more efficiently. The efficiency rating from condensing boilers ranges from between 80% to 98%.
Combi boiler / Combination boiler
Combi boiler / Combination boiler is an excellent choice for homes with limited space. Combi boiler / Combination boiler is a domestic water heater and a central heating system combined into one unit. They have a heating coil inside of them, and function like an unlimited on-demand water heater. Combi boilers don’t have cylinders or external holding tanks like traditional systems do, so they can be installed in areas where a typical system would never work.
Condensing Boiler Pros
1 They are fuel economy and have a 15-30% higher efficiency rating than non-condensing counterparts
2 Considerable savings on annual energy expenses
3 Most units are very quiet ( they make as much noise as a window-mounted air conditioner)
4 Many Models could easily fit in a small closet and have a combination boiler
5 They are more environmentally friendly with C02 output
Condensing Boiler Cons
1 Initial cost of the unit is more
2 Units need to have the acidic condensate fitted outside or to a waste line
3 The dwelling the boiler is installed in needs to be insulated well, otherwise, the heat saved through efficiency will be lost through the walls.
4 Most units need an outdoor weather sensor to operate effectively
For Poynton Green Shropshire SY4 Systems We Normally Advise Buying From The Our Recommended Combi Boiler Range
It is important to maintain boiler systems properly. The best way to do this is to get your boiler serviced frequently. Experts and manufacturers themselves recommend getting your boilers serviced at least once a year, to be on the safe side. Servicing a boiler can make it more efficient and increase its performance. This keeps it in a good and functional condition, making it last longer. Although the sound of servicing your boiler might seem expensive, especially on a yearly basis, the cost will only go up the longer you put it off. In addition to this, it can become harmful and dangerous to all those living in the same house.
A yearly servicing is the recommended frequency; however, there are a few exceptions to this rule that must be taken into account for. Moving into a new house with a boiler already installed needs to be serviced too before it is used. You cannot be sure how old the boiler is, or how long it has been since it was last used or serviced, so it is always best to be safe than sorry. Also, it is recommended to get your boiler serviced if you have been on an extended holiday where no-one has been at home to use the said boiler. A dormant boiler can be filled with anti-freeze that must be drained before use once again. Also, once again, after not being in use for a long time, you cannot be sure of the condition of the boiler. There may be clogged or broken parts which to someone who isn’t trained in the profession of servicing boilers would be unaware of.
The best time for getting a boiler service done is in between August and October, the last few months of summer. Not only is this after the holiday period, where you might have left the boiler unused for some amount of time, but these months are the in the off-peak season so many service providers would be both available and able to offer you a discount. This means that you can save on money and get a good, professional service from a trained and licensed expert without any hassle. Leaving the service for even a few weeks after this time period will see a rise in the price and the busyness of the workmen as winter comes around and boilers start to break and need fixing.
A good boiler service provider is someone who has a good reputation and is qualified. Finding someone like this isn’t hard, as there are many professionals out there, however, it is essential that you make sure that the person you choose to hire is an expert in the boiler servicing field. Checking a person’s or a company’s licenses can be easily done by logging onto the Gas Safe Register in the United Kingdom and looking up their names. The industry of boiler servicing is very lucrative, with many of your local companies and independent workers offering competitive prices for a variety of different services including boiler servicing. It is important not to get too distracted by the pricing when hiring someone to do the job.
Your boiler system manual is the best place to start when looking for information about its servicing. The manufacturer can also help you by answering any questions you might have that are not mentioned in the manual. Phone numbers and email addresses are usually provided with the manual, but if not, it can be easily found on the internet.