A gas boiler, fuelled with natural gas, oil, LPG or propane (etc), is the most common kind of appliance used for central heating in Hadnall Shropshire SY4 and throughout the United Kingdom. It heats water which flows through pipes or a radiator, and it is used for hot water in the home as well as for a central heating system. It is also used for radiant floor heating systems. An annual boiler inspection and maintenance check by a registered “Gas Safe” gas boiler service heating engineer is essential for safety and comply with UK Law.
The Engineer will make sure that the heating system is installed according to regulations during the annual central heating and boiler inspection, that it is safe and it is working efficiently according to the manufacturers’ instructions. If this is done properly every year, gas boiler breakdowns and the resulting emergency repair work can often be avoided.
Hadnall Shropshire SY4 High Energy Efficiency Combi Boiler Inspection – 5 Things You Should to Know
By opting for a condensing boiler to convert energy of natural gas to heat your home or apartment you are not only helping yourself by saving on heating bills but also make possible environmental well being while helping the whole world.
Wasted energy = wasted money
Whatever the fuel type may be, is said to be efficient about 90% at the lower end and - 98% at the upper. Your 15 year or so old traditional oil fired boiler is at least 12% less efficient than this. Whether it is gas or oil, you can imagine how much fossil fuel the high efficiency boiler would conserve, how much CO2 emission it would curtail and the pile of moolah you would save during the next 30 or 40 year plus life span.
What makes a condensing boiler more efficient?
A traditional gas burning boiler or a condensing boiler of recent vintage technology is not different to any oil burning boiler in basic working mechanism. The extra bit of efficiency in boiler is due to the condensation of water of combustion from steam state to liquid, releasing the latent heat of vaporisation. (Sadly if not for the condensing boiler, this huge percentage of heat energy will be sent up through the chimney as flue gases, without the home owner having a clue to what's happening). Inherently any boiler can achieve fuel efficiencies of 90% upwards easily.
A centralized heating system, incorporating a condenser boiler depends on several other system components. These would include the control system, DHW cylinders, Terminal units such as radiators etc. Unless there is a collectively efficient system in operation the ultimate overall efficiency will not be as desired.
Proprietary Brands and advanced designs
Proprietary brands such as Viessmann, a world leader in this field have developed technologies such as their stainless steel Inox-radial heat exchangers for natural gas combustion, capable of extracting almost to the end of last wave of thermal energy otherwise just wasted. Vitotronic controls (microprocessor based control system), Vitocell domestic hot water cylinder, lambda pro control combustion controls (a metering system that adjust the combustion process to the properties of any gaseous fuel) are other advanced features developed by them. The ultimate result is a very welcome consistent fuel efficiency of about 98%.
Boiler Maintenance and Repair Tips
There comes a time in every homeowner's life when they must wrestle with the decision of whether or not they should repair their existing heating system, or bite the bullet and purchase a new one. Boilers and furnaces are one of the most expensive pieces of equipment in your home, so naturally you want to get as many years of service out of them as possible. Yet some times, it just doesn't make sense to make small repairs on a unit well past its prime.
The best way to prolong your system's lifespan is to ensure you have your system professionally serviced annually. This will help ensure the unit is running at maximum efficiency. It will also ensure that small problems are brought to light before they become larger expenses. However, when problems do come up, consider the following:
Is the problem easily fixable?There are many components of a HVAC unit that can easily be replaced; yet when some parts go it is much more difficult to fix. For example, ignition modules, thermocouples, or zone controls are all components that are easily replaced on heating systems. Yet, when a section of your boiler cracks, there is not much you can do except purchase a new unit.
Likewise, on air conditioners and heat pumps - many things can go wrong which are fixable. But when the evaporator coil or the condenser fails they are not easily repaired. And one of these parts needs to be replaced, it is best to replace the other with a compatible unit. Coils and condensers which are not matched can function together, but will not run optimally. Mismatched units will show decreases in performance, increased energy use, and premature system failure. So despite the higher initial cost, it is a smarter move to replace both components at the same time for maximum efficiency and prolonged equipment life.
Is the equipment inefficient?Another point of consideration is whether or not it pays to keep an outdated piece of equipment running in your home. If your boiler or furnace is over 15 years old, the efficiency is probably somewhere between 50-75%. Newer high efficiency models are between 85-95% efficient. Replacing an outdated unit with a new high efficiency model will save you money on your fuel bill.
What can go wrong next? If you have an older piece of equipment, you also must consider what may go wrong next. Making multiple small repairs can add up fast. If your unit is fixable, but the cost of repair is high, you may want to consider replacement. While it will be more expensive up front, you will save money in small repairs down the road, as well as save yourself a few headaches.
For Hadnall Shropshire SY4 Systems We Usually Advise Purchasing From The Vaillant Combi Boiler Range
High efficiency. Space saver. Low costs. These are all important to homeowners who need to heat their home and use hot water. One of the most popular units is the condensing combi boiler that not only provides hot water, but it also reduces the operation and installation costs that other boilers have. This type of boiler works like a central heating boiler and a hot water cylinder at the same time. The name comes from the combination of a condensing boiler and a standard combination boiler. Cold water is instantly heated through a secondary heating circuit, which means that hot water is not stored. Therefore, consumers receive an unlimited supply of hot water for as long as the boiler is firing. Hot water is available within 40 seconds, so a person does not have to run water for a lengthy period of time before it reaches the desired temperature. Consumers save on water and heating costs.
A preferred choice for small homes, condensing combi boilers eliminate the need for some of the requirements that come with more conventional vented heating systems. For example, a separate hot and cold water tank is not required. Also, parts come in a single unit, rather than in separate pieces, which makes the boiler easy to install. By installing a thermostat, water is controlled in the shower, avoiding sudden temperature fluctuation.
The costs for owning one of these units can be somewhat expensive. However, there are some units that qualify for the 2009/2010 tax credit offered by the Federal government. The Embassy Onex is the latest addition to the ambassador line of condensing combi boilers with increased efficiency levels with the indoor/outdoor reset control feature. The Embassy Onex boiler costs approximately $4,275, but qualifies for the $1,500 tax credit. Additional features include a patented ASME heat exchanger; premix burner technology; and, a certified DOE efficiency rating of 93%.
Another condensing combi boiler which qualifies for the tax credit is the Viessmann WB24272, a natural gas unit that costs $5,964.95. The AFUE rating is 95.2%, and the unit comes with a stainless steel plate heat exchanger for instant heating. These boilers do not store water in the cylinder like other boilers, which can waste heat and contribute to adverse environmental conditions.