A gas boiler, fuelled with natural gas, oil, LPG or propane (etc), is the most common kind of appliance used for central heating in Habberley Shropshire SY5 and throughout the United Kingdom. It heats water which flows through pipes or a radiator, and it is used for hot water in the home as well as for a central heating system. It is also used for radiant floor heating systems. An annual boiler inspection and maintenance check by a registered “Gas Safe” gas boiler service heating engineer is essential for safety and comply with UK Law.
The Engineer will make sure that the heating system is installed according to regulations during the annual central heating and boiler inspection, that it is safe and it is working efficiently according to the manufacturers’ instructions. If this is done properly every year, gas boiler breakdowns and the resulting emergency repair work can often be avoided.
Habberley Shropshire SY5 High Energy Efficiency Combi Boiler Inspection – 5 Things You Will Want to Take Note Of
Oil fired condensing boilers are just starting to be used in the United States. There are some obstacles to overcome and some great advantages to condensing oil technology.
One of the main reasons that they have not been used more is because of the lack of low-sulphur heating oil being readily available. A condensing oil boiler must burn the low-sulphur heating oil for it to work properly. As more and more of these units are sold in different areas of the US the right fuels will become more readily available.
Modern oil condensing boilers can save you as much as 30% more energy than many conventional boilers. A modern oil condensing boiler will not only heat more efficiently, but because of this it will reduce your heating oil consumption. When low-sulphur heating oil or heating oil with biogenic additives are used in an oil condensing boiler, it then becomes almost as environmentally friendly as using natural gas.
If your boiler is more than 15 years old, replacing it with a new condensing boiler, of the right heat output for your property size, should save you around a third on your heating oil bills. If you plan to install a new boiler or to replace an existing one, in some cases you will need to install a condensing boiler to meet today's higher standards for energy efficiency required under many building codes. Today's new boilers are not only smaller, neater, they also take up less space, Therefore they are much more energy efficient and therefore use less fuel to produce the same amount of BTU's. A typical conventional boiler burns fuel in a combustion chamber that is surrounded by a water jacket. Condensing boilers also extract the heat from the products of combustion using a secondary heat exchanger.
A condensing combi boiler is a boiler that will heat your home and provide you with instantaneous hot water, without adding a hot water tank. Most of these boilers use a coil that is immersed in the hot water inside the boiler. The cold water is run through the coil and the heat is transferred from the boiler water to the domestic water. These boilers make the production of your hot water very efficient also.
Condensing oil boilers basically are not that much different than conventional boilers. They just are designed so that they reduce the flue gases temperature to the point where the water vapor in the exhaust is cooled to the point where it condenses. This condensing feature also releases the latent heat in the flue gases. This heat is also collected and used to heat you home.
Condensing boilers are not only a great deal for new construction, but they can also be used to upgrade many old heating systems. They are nearly the same size as older boilers and in some cases they are smaller. The piping may have to be reconfigured a bit, but a good contractor can fit an oil fired condensing boiler easily into any system. You gain will be a highly efficient and comfortable heating system.
High Efficiency Condensing Boilers and Combination Boilers
Gas boilers normally extract the air they require for combustion either from inside the heated area or straight from the outside. Extracting air directly from outside, characteristically via a plastic pipe that moves through an outside wall, is more effective and secure.
This system is generally referred to as 'sealed combustion', since the gas is burned in a chamber that is blocked to engaged areas. This arrangement almost removes any hazard in the event of combustion gases seeping out into engaged areas.
The efficiency of gas boilers can be greatly increased by incorporating motorized dampers that block the flue pipe outlet when the boiler is not in use. This helps in preventing the loss of heated room air between boiler cycles. Another way to increase the efficiency of gas boilers is by using electric ignition. This does away with the necessity for a standing pilot light.
Gas boiler efficiency can also be enhanced by fan-assisted combustion systems, which do not call for a very big natural draft chimney and can be relieved through a minor flue pipe straight through a wall. Gas boilers, in reality, operate best at full load. When their intensity is lessened, they can drop by as much 20 percentage points in efficiency.
If building requirements are diverse, as is common in commercial buildings, multiple boilers are considered to be highly suitable. Generally, small gas boilers that function effectively are considered a better option than the most suitable of the bigger gas boilers. As has been observed, a number of small boilers can function more competently than a single big system. The reason is that each gas boiler can function frequently close to its full load, which is the most important yardstick for a gas boiler to function in an effective manner.
For Habberley Shropshire SY5 Systems We Usually Advise Purchasing From The Our Recommended Combi Boiler Range
When the cold weather starts to show its nasty face, we all know that it won't be long before the home central heating is switched on to keep us warm. Sometimes though it decides not to work and you have to find someone who knows how to fix it.
A very small percentage of people have their boiler serviced every year without fail, these are the people who prepare for the colder months, knowing that when they need the heating on it will all be fine.
The majority of people though these days seem to forget or just don't bother to have the boiler serviced until it breaks down. The boiler is just like a car, you need to have the car checked over and oil added if needed, otherwise it will eventually breakdown.
I have listed 5 reasons below on why you should have the boiler serviced.
- One of the mains reasons why your boiler should be serviced each year is safety. When a service is carried out the flue pipe that removes the exhaust gas is checked over for leakage. Should a leak in the flue pipe be found, it could be producing carbon monoxide into the room that the boiler is located in, and we all know how dangerous to life it can be.
- We all like to keep warm in the winter months, but can you imagine coming home from work on a very cold evening only to find your home is cold because the boiler has stopped.
- The boiler fitted in your property normally supplies both hot water and heating throughout your home, should the boiler stop working you may find yourself taking a cold shower.
- If your boiler is either a combination or system boiler then it will be fitted with an expansion vessel somewhere, it could be fitted internal of the boiler or fitted externally close to the boiler. This vessel over time will loose its pressure and needs to be reset.
- The boilers of today are very highly tuned to give you the user the efficiency you require, when the service is carried out, the boiler is connected to a gas analyser to check on it efficiency and safety. Should the boiler need adjustments then it can be adjusted and checked over again.
If your boiler is around 11 years old or younger it will most likely be a high efficient condensing boiler. These boilers are not like the old style boilers that went on for many years without having a service. Those boilers were very costly to use, around 40% of your fuel bill went out of the boilers flue.
Today's condensing boilers have an efficiency rating of around 90%, that's a saving of around 30% on your fuel bill, but if fail to have the boiler serviced you will start see your fuel bills rise along with the fuel suppliers regular increase.
It's very important to have a regular boiler service because it will also increase the life of the boiler, if left then the life span becomes very low, and you will be changing the boiler at some stage, and we all know how costly that can be.
Top Tip, When you find someone to service your boiler, if the boiler works by gas then you must use a Gas Safe Registered Engineer to carry out the work for you. You must not use a friend or someone who says don't worry I can do it for you unless they are registered.
The boiler when working keeps us all warm with plenty of hot water, but when it stops it become a headache.