A gas boiler, fuelled with natural gas, oil, LPG or propane (etc), is the most common kind of appliance used for central heating in Great Wytheford Shropshire SY4 and throughout the United Kingdom. It heats water which flows through pipes or a radiator, and it is used for hot water in the home as well as for a central heating system. It is also used for radiant floor heating systems. An annual boiler inspection and maintenance check by a registered “Gas Safe” gas boiler service heating engineer is essential for safety and comply with UK Law.
The Engineer will make sure that the heating system is installed according to regulations during the annual central heating and boiler inspection, that it is safe and it is working efficiently according to the manufacturers’ instructions. If this is done properly every year, gas boiler breakdowns and the resulting emergency repair work can often be avoided.
Great Wytheford Shropshire SY4 High Energy Efficiency Combi Boiler Inspection – 5 Things You Need to Take Note Of
Oil fired condensing boilers are just starting to be used in the United States. There are some obstacles to overcome and some great advantages to condensing oil technology.
One of the main reasons that they have not been used more is because of the lack of low-sulphur heating oil being readily available. A condensing oil boiler must burn the low-sulphur heating oil for it to work properly. As more and more of these units are sold in different areas of the US the right fuels will become more readily available.
Modern oil condensing boilers can save you as much as 30% more energy than many conventional boilers. A modern oil condensing boiler will not only heat more efficiently, but because of this it will reduce your heating oil consumption. When low-sulphur heating oil or heating oil with biogenic additives are used in an oil condensing boiler, it then becomes almost as environmentally friendly as using natural gas.
If your boiler is more than 15 years old, replacing it with a new condensing boiler, of the right heat output for your property size, should save you around a third on your heating oil bills. If you plan to install a new boiler or to replace an existing one, in some cases you will need to install a condensing boiler to meet today's higher standards for energy efficiency required under many building codes. Today's new boilers are not only smaller, neater, they also take up less space, Therefore they are much more energy efficient and therefore use less fuel to produce the same amount of BTU's. A typical conventional boiler burns fuel in a combustion chamber that is surrounded by a water jacket. Condensing boilers also extract the heat from the products of combustion using a secondary heat exchanger.
A condensing combi boiler is a boiler that will heat your home and provide you with instantaneous hot water, without adding a hot water tank. Most of these boilers use a coil that is immersed in the hot water inside the boiler. The cold water is run through the coil and the heat is transferred from the boiler water to the domestic water. These boilers make the production of your hot water very efficient also.
Condensing oil boilers basically are not that much different than conventional boilers. They just are designed so that they reduce the flue gases temperature to the point where the water vapor in the exhaust is cooled to the point where it condenses. This condensing feature also releases the latent heat in the flue gases. This heat is also collected and used to heat you home.
Condensing boilers are not only a great deal for new construction, but they can also be used to upgrade many old heating systems. They are nearly the same size as older boilers and in some cases they are smaller. The piping may have to be reconfigured a bit, but a good contractor can fit an oil fired condensing boiler easily into any system. You gain will be a highly efficient and comfortable heating system.
Boiler Servicing - Essential Tips and Ideas
Combi boilers have a lot of advantages over conventional boilers, but also a few small drawbacks. This article will open your eyes to the things you should consider when purchasing a cheaper model. There are many models of combi boilers available in the market, and like in every other product, the price usually matches the quality and determines the results (you get what you pay for).
1) Possible scaling of the DHW heat exchanger
If the water company in your area, supplies you with hard water, chances are that your DHW heat exchanger will scale with time. In that scenario, you will have two choices; either replace it with an original piece from the manufacturer (which won't be cheap), or replace the whole boiler. Of course this problem can occur with any conventional tank as well, as this is one of the effects of hard waters. The latest and more expensive combi boilers are already designed to reduce scaling as much as possible. Another thing you could do is run softened water through it, but that would definitely invalidate your warranty.
2) No option of electric immersion heater
With a conventional water storage tank, if for some reason the boiler fails, you have the option of using an emergency electric immersion heater. But the combi boiler is tankless and this option would not be valid.
3)Possible incompatibility between gas pipes
You may need to upgrade the gas supply pipe, because the diameter may not comply with the regulations for installing combi boilers.
4)Good showers, slower baths
Although one of the combis' strengths is to be able to deliver high pressurized water in both your hot and cold taps, a cheaper model may have a modest flow rate of hot water. That is no problem if you are a shower person, because it will supply just what you need to take a nice hot shower. Nevertheless, it maybe a little slower for your bathtub to fill up.
5)It does not deliver instant hot water to all taps
If the boiler is far away from the tap you are using, it may take a few minutes for the hot water to come through, as it has to travel through many meters of cold water filled pipes. This is not a problem when filling up a tub or taking a shower, but if you just want instant hot water to wash your hands or fill up a basin, it may be irritating to have to wait and see an amount of cold water being wasted down the drain.
For Great Wytheford Shropshire SY4 Systems We Often Advise Purchasing From The Vaillant Combi Boiler Range
When the cold weather starts to show its nasty face, we all know that it won't be long before the home central heating is switched on to keep us warm. Sometimes though it decides not to work and you have to find someone who knows how to fix it.
A very small percentage of people have their boiler serviced every year without fail, these are the people who prepare for the colder months, knowing that when they need the heating on it will all be fine.
The majority of people though these days seem to forget or just don't bother to have the boiler serviced until it breaks down. The boiler is just like a car, you need to have the car checked over and oil added if needed, otherwise it will eventually breakdown.
I have listed 5 reasons below on why you should have the boiler serviced.
- One of the mains reasons why your boiler should be serviced each year is safety. When a service is carried out the flue pipe that removes the exhaust gas is checked over for leakage. Should a leak in the flue pipe be found, it could be producing carbon monoxide into the room that the boiler is located in, and we all know how dangerous to life it can be.
- We all like to keep warm in the winter months, but can you imagine coming home from work on a very cold evening only to find your home is cold because the boiler has stopped.
- The boiler fitted in your property normally supplies both hot water and heating throughout your home, should the boiler stop working you may find yourself taking a cold shower.
- If your boiler is either a combination or system boiler then it will be fitted with an expansion vessel somewhere, it could be fitted internal of the boiler or fitted externally close to the boiler. This vessel over time will loose its pressure and needs to be reset.
- The boilers of today are very highly tuned to give you the user the efficiency you require, when the service is carried out, the boiler is connected to a gas analyser to check on it efficiency and safety. Should the boiler need adjustments then it can be adjusted and checked over again.
If your boiler is around 11 years old or younger it will most likely be a high efficient condensing boiler. These boilers are not like the old style boilers that went on for many years without having a service. Those boilers were very costly to use, around 40% of your fuel bill went out of the boilers flue.
Today's condensing boilers have an efficiency rating of around 90%, that's a saving of around 30% on your fuel bill, but if fail to have the boiler serviced you will start see your fuel bills rise along with the fuel suppliers regular increase.
It's very important to have a regular boiler service because it will also increase the life of the boiler, if left then the life span becomes very low, and you will be changing the boiler at some stage, and we all know how costly that can be.
Top Tip, When you find someone to service your boiler, if the boiler works by gas then you must use a Gas Safe Registered Engineer to carry out the work for you. You must not use a friend or someone who says don't worry I can do it for you unless they are registered.
The boiler when working keeps us all warm with plenty of hot water, but when it stops it become a headache.