A gas boiler, fuelled with natural gas, oil, LPG or propane (etc), is the most common kind of appliance used for central heating in Woolstaston Shropshire SY6 and throughout the United Kingdom. It heats water which flows through pipes or a radiator, and it is used for hot water in the home as well as for a central heating system. It is also used for radiant floor heating systems. An annual boiler inspection and maintenance check by a registered “Gas Safe” gas boiler service heating engineer is essential for safety and comply with UK Law.
The Engineer will make sure that the heating system is installed according to regulations during the annual central heating and boiler inspection, that it is safe and it is working efficiently according to the manufacturers’ instructions. If this is done properly every year, gas boiler breakdowns and the resulting emergency repair work can often be avoided.
Woolstaston Shropshire SY6 High Energy Efficiency Combi Boiler Inspection – A Number of Things You Need to Know
When the cold weather starts to show its nasty face, we all know that it won't be long before the home central heating is switched on to keep us warm. Sometimes though it decides not to work and you have to find someone who knows how to fix it.
A very small percentage of people have their boiler serviced every year without fail, these are the people who prepare for the colder months, knowing that when they need the heating on it will all be fine.
The majority of people though these days seem to forget or just don't bother to have the boiler serviced until it breaks down. The boiler is just like a car, you need to have the car checked over and oil added if needed, otherwise it will eventually breakdown.
I have listed 5 reasons below on why you should have the boiler serviced.
- One of the mains reasons why your boiler should be serviced each year is safety. When a service is carried out the flue pipe that removes the exhaust gas is checked over for leakage. Should a leak in the flue pipe be found, it could be producing carbon monoxide into the room that the boiler is located in, and we all know how dangerous to life it can be.
- We all like to keep warm in the winter months, but can you imagine coming home from work on a very cold evening only to find your home is cold because the boiler has stopped.
- The boiler fitted in your property normally supplies both hot water and heating throughout your home, should the boiler stop working you may find yourself taking a cold shower.
- If your boiler is either a combination or system boiler then it will be fitted with an expansion vessel somewhere, it could be fitted internal of the boiler or fitted externally close to the boiler. This vessel over time will loose its pressure and needs to be reset.
- The boilers of today are very highly tuned to give you the user the efficiency you require, when the service is carried out, the boiler is connected to a gas analyser to check on it efficiency and safety. Should the boiler need adjustments then it can be adjusted and checked over again.
If your boiler is around 11 years old or younger it will most likely be a high efficient condensing boiler. These boilers are not like the old style boilers that went on for many years without having a service. Those boilers were very costly to use, around 40% of your fuel bill went out of the boilers flue.
Today's condensing boilers have an efficiency rating of around 90%, that's a saving of around 30% on your fuel bill, but if fail to have the boiler serviced you will start see your fuel bills rise along with the fuel suppliers regular increase.
It's very important to have a regular boiler service because it will also increase the life of the boiler, if left then the life span becomes very low, and you will be changing the boiler at some stage, and we all know how costly that can be.
Top Tip, When you find someone to service your boiler, if the boiler works by gas then you must use a Gas Safe Registered Engineer to carry out the work for you. You must not use a friend or someone who says don't worry I can do it for you unless they are registered.
The boiler when working keeps us all warm with plenty of hot water, but when it stops it become a headache.
The Condensing Oil Boiler - Is it the Right Choice For You?
There comes a time in every homeowner's life when they must wrestle with the decision of whether or not they should repair their existing heating system, or bite the bullet and purchase a new one. Boilers and furnaces are one of the most expensive pieces of equipment in your home, so naturally you want to get as many years of service out of them as possible. Yet some times, it just doesn't make sense to make small repairs on a unit well past its prime.
The best way to prolong your system's lifespan is to ensure you have your system professionally serviced annually. This will help ensure the unit is running at maximum efficiency. It will also ensure that small problems are brought to light before they become larger expenses. However, when problems do come up, consider the following:
Is the problem easily fixable?There are many components of a HVAC unit that can easily be replaced; yet when some parts go it is much more difficult to fix. For example, ignition modules, thermocouples, or zone controls are all components that are easily replaced on heating systems. Yet, when a section of your boiler cracks, there is not much you can do except purchase a new unit.
Likewise, on air conditioners and heat pumps - many things can go wrong which are fixable. But when the evaporator coil or the condenser fails they are not easily repaired. And one of these parts needs to be replaced, it is best to replace the other with a compatible unit. Coils and condensers which are not matched can function together, but will not run optimally. Mismatched units will show decreases in performance, increased energy use, and premature system failure. So despite the higher initial cost, it is a smarter move to replace both components at the same time for maximum efficiency and prolonged equipment life.
Is the equipment inefficient?Another point of consideration is whether or not it pays to keep an outdated piece of equipment running in your home. If your boiler or furnace is over 15 years old, the efficiency is probably somewhere between 50-75%. Newer high efficiency models are between 85-95% efficient. Replacing an outdated unit with a new high efficiency model will save you money on your fuel bill.
What can go wrong next? If you have an older piece of equipment, you also must consider what may go wrong next. Making multiple small repairs can add up fast. If your unit is fixable, but the cost of repair is high, you may want to consider replacement. While it will be more expensive up front, you will save money in small repairs down the road, as well as save yourself a few headaches.
For Woolstaston Shropshire SY6 Systems We Usually Suggest Purchasing From The Top Combi Boiler Range
By opting for a condensing boiler to convert energy of natural gas to heat your home or apartment you are not only helping yourself by saving on heating bills but also make possible environmental well being while helping the whole world.
Wasted energy = wasted money
Whatever the fuel type may be, is said to be efficient about 90% at the lower end and - 98% at the upper. Your 15 year or so old traditional oil fired boiler is at least 12% less efficient than this. Whether it is gas or oil, you can imagine how much fossil fuel the high efficiency boiler would conserve, how much CO2 emission it would curtail and the pile of moolah you would save during the next 30 or 40 year plus life span.
What makes a condensing boiler more efficient?
A traditional gas burning boiler or a condensing boiler of recent vintage technology is not different to any oil burning boiler in basic working mechanism. The extra bit of efficiency in boiler is due to the condensation of water of combustion from steam state to liquid, releasing the latent heat of vaporisation. (Sadly if not for the condensing boiler, this huge percentage of heat energy will be sent up through the chimney as flue gases, without the home owner having a clue to what's happening). Inherently any boiler can achieve fuel efficiencies of 90% upwards easily.
A centralized heating system, incorporating a condenser boiler depends on several other system components. These would include the control system, DHW cylinders, Terminal units such as radiators etc. Unless there is a collectively efficient system in operation the ultimate overall efficiency will not be as desired.
Proprietary Brands and advanced designs
Proprietary brands such as Viessmann, a world leader in this field have developed technologies such as their stainless steel Inox-radial heat exchangers for natural gas combustion, capable of extracting almost to the end of last wave of thermal energy otherwise just wasted. Vitotronic controls (microprocessor based control system), Vitocell domestic hot water cylinder, lambda pro control combustion controls (a metering system that adjust the combustion process to the properties of any gaseous fuel) are other advanced features developed by them. The ultimate result is a very welcome consistent fuel efficiency of about 98%.